Wallboard joints are normally finished using three coats of compound; the first to embed the tape; the second to cover the tape, and the third to finish the joint. CertainTeed Sandable Setting-Type Compound can be used for the first and second coats. Although the third coat is typically done
with a ready-mix product, the Sandable Setting-Type Compounds can be used as well.
For joint reinforcement the use of Fibreglass mesh tape is recommended.
Apply the first coat to the joint in a band about 64 mm (2-1/2") wide.
Center CertainTeed mesh tape over joint and embed with a broad knife.
Allow to set, as per product specifications on the package.
These compounds generate heat as they harden. Keep the compound away from exposed skin during the hardening process to prevent burns.
Do not apply or re-mix after it has started to set.
Compound must be applied to a clean, dry surface.
Use is limited for above grade applications.
When mixing and/or dry sanding, wear safety glasses and dust mask approved by NIOSH/MSHA.
Keep out of reach of children.
Allow to dry for 24 hours before sanding. Use 120 grit sand-paper and a hand or pole sander. Do not sand the surface of the wallboard paper.
For complete installation details, please see Installation Guide or Install Like the Pros.